Set Relay Configuration

The Relay Configuration tab is used to:

• Select the relay mode.

• Create the relay tooltip to be displayed in the GlobalViewer® interface.

• Create the relay Open label to be displayed in the GlobalViewer interface.

• Create the relay Close label to be displayed in the GlobalViewer interface.

To configure an IPI 201 or IPI 204 relay:

1. From the Mode drop-down list in the Relay Configuration section, select the desired mode.  Options include:

2. Open/Close - 2 Push Button

3. Toggle - 1 Push Button

4. Pulse - 1 Push Button

If Open/Close - 2 Push Button is the selected mode, then:

1. In the Tooltip field, enter the desired tooltip.

2. In the Open Label field, enter a unique Open label.

3. In the Close Label field, enter a unique Close label.

If Toggle - 1 Push Button is the selected mode, then:

1. In the Tooltip field, enter the desired tooltip.

2. In the Toggle label field, enter a unique Toggle label.

Note:  This button refers to the button that appears in GlobalViewer to represent the relay.

If Pulse - 1 Push Button is the selected mode, then:

1. In the Tooltip field, enter the desired tooltip.

2. In the Pulse Label field, enter a unique Pulse label.

3. In the Pulse Time field, enter the desired pulse time (0.1 to 1310.7 seconds).

Note:  This button refers to the button that appears in GlobalViewer to represent the relay.