| FOXBOX Rx HDMI Series |
| NOTE | The analog audio signal(s) is (are) digitized in the transmitter, sent through the fiber cable, and converted back to analog audio in the receiver. |
|
| NOTE | These transceivers are class 1 laser products. They meet the safety regulations of IEC-60825. |
|
|
| Optical fiber interconnection between transmitter and receiver |
|---|
| Number/type | 2 fiber optic |
| Connectors | 2 LC connectors |
| Operating distance | |
| Singlemode | 30 km (18.75 miles) with singlemode (SM) cables |
| Multimode | 300 m (985') with 62.5 µm OM1 multimode (MM) cables
1 km (3280') with 50 µm OM2 multimode (MM) cables
2 km (6561') with 50 µm OM3/OM4 2000 MHz bandwidth laser optimized multimode cable |
| NOTE | Operating distance is approximate. These are typical maximum distances that may vary depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks. |
|
| Nominal peak wavelength | 850 nm for MM, 1310 nm for SM |
| Data rate | 4.25 Gbps |
| Transmission power | |
| Singlemode | -5 dBm, typical |
| Multimode | -5 dBm, typical |
| Maximum receiver sensitivity | |
| Singlemode | -18 dBm, typical |
| Multimode | -12 dBm, typical |
| Optical loss budget | |
| Singlemode | 13 dB, maximum |
| Multimode | 7 dB, maximum |
|
| Video |
|---|
| NOTE | *Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output. |
|
| Resolution range | 640x480 up to 1920x1200 @ 60Hz, including 480p, 576p, 720p, 1080i, 1080p @ 60Hz, sampled pixel for pixel; higher resolution 2K (2048x1080) @ 60 Hz, undersampled |
| Formats | RGB and YCbCr digital video |
| EDID | Supports emulation of custom or factory preset Extended Display Identification Data (EDID) tables. |
| HDCP | Compliant with High-bandwidth Digital Content Protection (HDCP) using DVI and HDMI standards |
| Standards | DVI 1.0, HDMI, HDCP 1.1, CEA-861E |
|
| Video input — See the FOXBOX Tx HDMI transmitters specifications |
|---|
|
| Video output |
|---|
| Number/signal type | 1 single link HDMI |
| Connectors | 1 female HDMI type A |
| Nominal level | 0.8 Vp-p |
| Video delay | 1-2 frames |
|
| Audio |
|---|
| Gain | |
| Range | Adjustable, -18 dB to +10 dB |
| Default | Unbalanced output: -6 dB; balanced output: 0 dB |
| Frequency response | 20 Hz to 20 kHz, ±0.5 dB |
| THD + Noise | 0.10% @ 1 kHz at nominal level |
| S/N | >80 dB at maximum output (unweighted) |
| CMRR | 65 dB @ 20 Hz to 20 kHz |
| Audio bits per sample | 18 bits per channel, 2 channels (L, R) |
| Sampling rate | 48 kHz |
|
| Audio input — See the FOXBOX Tx HDMI transmitters specifications |
|---|
|
| Audio output |
|---|
| Number/signal type | 1 stereo/mono, balanced/unbalanced |
| Connectors | (1) 3.5 mm captive screw connector, 5 pole
1 female HDMI, type A (shared with HDMI video) |
| Impedance | 50 ohms unbalanced |
| Nominal level | -10 dBV (316 mVrms) |
| Maximum level (Hi-Z) | >+11.0 dBu, balanced at 1% THD+N |
| Maximum level (600 ohm) | >10.0 dBu, balanced at 1% THD+N |
| Audio delay | 1.5 frames |
| NOTE | 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu |
|
|
| Communications — receiver |
|---|
| Serial control ports on each unit |
| Control | 1 RS-232, 2.5 mm mini stereo jack (front panel)
1 RS-232, 3.5 mm captive screw connector, 3-pole (rear panel) |
| Pass-through | 1 RS-232, 3.5 mm captive screw connector, 5-pole (3 pins are used) (rear panel) |
| Baud rate and protocol | |
| Control | 9600 baud, 8 data bits, 1 stop bit, no parity |
| Pass-through | 9600 to 115,200 baud |
| Serial control pin configuration | Mini stereo jack: tip = Tx, ring = Rx, sleeve = GND
Captive screw: 1 = Tx, 2 = Rx, 3 = GND |
| Program control | Extron control/configuration program for Windows®
Extron Simple Instruction Set (SIS™) |
|
| General |
|---|
| Power supply | External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1.5 A, 18 watts |
| Power consumption | |
| Device | 6.9 watts, 12 VDC |
| Device and power supply | 8.7 watts, 12 VDC |
| Ambient temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| Cooling | Convection, vents on top and side panels |
| Thermal dissipation | |
| Device | 22.1 BTU/hr |
| Device and power supply | 28.3 BTU/hr |
| Mounting | |
| Rack mount | Yes, with optional rack shelf |
| Furniture mount | Yes, with optional under desk mounting kit |
| Enclosure type | Metal |
| Enclosure dimensions | 1.0" H x 8.75" W x 6.0" D (half rack wide)
(2.5 cm H x 22.2 cm W x 15.2 cm D)
(Depth excludes connectors and switch.) |
| Product weight | 1.1 lbs (0.5 kg) |
| Regulatory compliance | CE, c-UL UL, CE**, C-tick, FCC Class A**, ICES, VCCI,
Complies with the appropriate requirements of RoHS, WEEE |
| Product warranty | 3 years parts and labor |
| Everlast power supply warranty | 7 years parts and labor |
| NOTE | All nominal levels are at ±10%. |
|
| NOTE | Specifications are subject to change without notice. |
|
| (4379-090718-D13 ) |