| MVX 128 Plus Series |
|
| Video |
|---|
| Routing | 12 x 8 matrix |
| Gain | Unity |
| Bandwidth | >300 MHz (-3 dB), fully loaded |
| 0 - 10 MHz | No more than +0.1 dB to -0.1 dB |
| 0 - 130 MHz | No more than +0.8 dB to -0.8 dB |
| Switching speed | 200 ns (max.) |
|
| Video input |
|---|
| Number/signal type | 12 RGBHV, RGBS, RGsB, RsGsBs, HDTV component video, component video, S-video, composite video |
| Connectors | 12 female 15-pin HD |
| Nominal level | 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video |
| Minimum/maximum levels | Analog: 0.5 V to 2.0 Vp-p with no offset |
| Impedance | 75 ohms |
| Return loss | <-30 dB @ 5 MHz |
| DC offset (max. allowable) | 1.5 V |
|
| Video output |
|---|
| Number/signal type | 8 RGBHV, RGBS, RGsB, HDTV component video, component video, S-video, composite video (follows input type) |
| Connectors | 8 female 15-pin HD |
| Nominal level | 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video |
| Minimum/maximum levels | 0 V to 2.0 Vp-p (follows input) |
| Impedance | 75 ohms |
| Return loss | -30 dB @ 5 MHz |
| DC offset | ±5 mV with input at 0 offset |
| Switching type | Triple-Action™ |
|
| Sync |
|---|
| Input type | RGBHV, RGBS, RGsB, RsGsBs |
| Output type | RGBHV, RGBS, RGsB, RsGsBs (follows input)
Tri-level on Y, R-Y, B-Y channels (component video 720p, 1080i, 1080p)
Bi-level on Y channel (for all other component video rates) |
| Input level | 0.5 V to 5.0 Vp-p, 4.0 Vp-p normal |
| Output level | AGC to TTL: 4.0 V to 5.0 Vp-p, unterminated |
| Input impedance | 510 ohms |
| Output impedance | 75 ohms |
| Max. input voltage | 5.0 Vp-p |
| Max. propagation delay | 30 ns |
| Max. rise/fall time | 4 ns |
| Polarity | Positive or negative (follows input) |
|
| Audio |
|---|
| Routing | 12 x 8 stereo matrix |
| Gain | Unbalanced output: -6 dB; balanced output 0 dB |
| Frequency response | 20 Hz to 20 kHz, ±0.05 dB |
| THD + Noise | 0.03% @ 1 kHz at nominal level |
| S/N | >90 dB, balanced, at maximum output (21 dBu), unweighted |
| Crosstalk | <-80 dB @ 1 kHz, fully loaded |
| Stereo channel separation | >80 dB @ 1 kHz |
| CMRR | >75 dB @ 20 Hz to 20 kHz |
|
| Audio input |
|---|
| Number/signal type | 12 stereo, balanced/unbalanced |
| Connectors | (12) 3.5 mm captive screw connectors, 5 pole |
| Impedance | >10k ohm, balanced/unbalanced, DC coupled |
| Nominal level | 0 dBV (316 mV)0 dBu (775 mV) |
| Maximum level | +19.5 dBu, (balanced or unbalanced) at 0.01% THD+N |
| Input gain adjustment | -18 dB to +24 dB, adjustable per input by RS-232/422, Ethernet, or front panel |
| NOTE | 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu |
|
|
| Audio output |
|---|
| Number/signal type | 8 stereo, balanced/unbalanced |
| Connectors | (8) 3.5 mm captive screw connectors, 5 pole |
| Impedance | 50 ohms unbalanced, 100 ohms balanced |
| Gain error | ±0.1 dB channel to channel |
| Maximum level (Hi-Z) | >+21 dBu, balanced or unbalanced at 0.10%THD+N |
| Maximum level (600 ohm) | >+15 dBm, balanced or unbalanced at 0.10%THD+N |
| Output volume range | 0 to 64 (-75.8 dB to 0 dB) in 1 dB increments from steps 1 to 64, 12 dB increment from step 0 to 1 |
|
| Control/remote — switcher |
|---|
| Serial control port | 1 RS-232 or RS-422, 9-pin female D connector |
| Baud rate and protocol | 9600 (default), 19200, 38400, 115200 baud (adjustable); 8 data bits, 1 stop bit, no parity |
| Serial control pin configurations | RS-232: 2 = TX, 3 = RX, 5 = GND
RS-422: 2 = TX-, 3 = RX-, 5 = GND, 7 = RX+, 8 = Tx+ |
| Ethernet control port | 1 RJ-45 female connector |
| Ethernet data rate | 10/100Base-T, half/full duplex with autodetect |
| Ethernet protocol | ARP, DHCP, ICMP (ping), TCP/IP, Telnet, HTTP |
| Program control | Extron's control/configuration program for Windows®
Extron's Simple Instruction Set (SIS™)
Microsoft® Internet Explorer, Telnet |
|
| General |
|---|
| Power | 100 VAC to 240 VAC, 50/60 Hz, 30 watts, internal |
| Ambient temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +113 °F (0 to +45 °C) / 10% to 90%, noncondensing |
| Cooling | Convection, vented |
| Rack mount | Yes, with included brackets |
| Enclosure type | Metal |
| Enclosure dimensions | 3.5" H x 19.0" W x 9.4" D (2U high, full rack wide)
8.9 cm H x 48.3 cm W x 23.9 cm D
(Depth excludes connectors. Width includes rack ears.) |
| Product weight | 14.4 lbs (6.5 kg) |
| Shipping weight | 21 lbs (10 kg) |
| DIM weight, international | 25 lbs (12 kg) |
| Vibration | ISTA 1A in carton (International Safe Transit Association) |
| Listings | UL, CUL |
| Compliances | CE, FCC Class A, VCCI, AS/NZS, ICES |
| Product warranty | 3 years parts and labor |
| NOTE | All nominal levels are at ±10%. |
|
| NOTE | Specifications are subject to change without notice. |
|
| (7.51-102407-D4) |